Full Scan Information Bug [M1967]

Discontinued Products Resolved/Outdated Issues - CCAV
1

1. What actually happened
I run a full scan and I stopped it at %15. On the Scan Menu “Last Scan date shown” Actually I did not finish the scan.
But CCAV counted this uncompleted scan as OK.
2. What you did to cause that to happen, step by step
i) Run your “first” full scan. (Scan must be first scan)
ii) Stop it before it finish.
iii) Open Scan menu, you will see the scan just like “it finished successfully” It is wrong.
I did not complete the scan
…
3. If you repeat these steps does the same thing always happen
Yes
4. What you expected or wanted to happen
Last scan time must be “Never” because I never completed a full scan.
5. Operating system, whether 32 or 64bit, and service pack number
Windows 10 Home 64bit Release 1607
CCAV full version number (from Help ~ About)
1.5.398119.328
6. Any other security or sandbox software installed now or previously
Only CCAV
7. Does this problem occur if you load the default configuration and reboot
Yes
8. Any other relevant information (eg Your guess at the reason for the bug)
N/A

2

Hello yigido,
Thanks for indicating a bug in CCAV. The bug has been reported and fix is done. It will be released by V1.7 of CCAV.

Kind regards,
PremJK

3

Thank you for the fix devs :-TU

4

Should be fixed with lastest CCAV version. If you still experience this issue please say so here or PM a board moderator. Thanks.