Comodo Inspect problem

1

I have for about a week now, trying to make my Comodo Firewall allow all traffic on my LAN network. When I have Comodo Inspect enabled, I can only transfer files from my main system to my other system on the same LAN network I use for editing at around 8-9mbps. However, if I disable Inspect, reboot, I can transfer in excess of 80-100mbps.

I have set a trusted lan in Network Zones in the firewall for 192.168.3.0/24, which should tell it to ignore traffic on LAN IPs from 192.168.3.1 to 192.168.3.245, but it doesn’t do anything.

I’ve even used ChatGPT to come up with suggestions & nothing seems to work unless I disable Inspect using Disable-NetAdapterBinding -Name “Ethernet” -ComponentID “inspect” in powershell.

I’m starting to consider ditching Comodo Firewall, something I’ve used for years because of this. As I’ve had enough now. So if any of you guys can suggest something, I’d appreciate it very much.

2

I should add, The evidence is strong that the bottleneck is specifically **COMODO inspect processing traffic through the I211 (Intel(R) I211 Gigabit Network Connection) adapter.

I have to fully disable inspect, reboot to establish full transfer speeds. Enabling, massively reduces my transfer speeds on single thread transfers.